There are some minor faults in the dryer sometimes, so what should we do to eliminate and repair these faults? What is the reason for these problems?
1. The meshing clearance between the large gear and the pinion of the dryer is broken. The reason is: a tug wear b retainer wear c pinion wear. The elimination method is to turn or replace according to the wear condition, or it can be installed or reversed. For updates.
2, the whole body vibration, the reason is that the connection between the a tug device and the base is broken, the elimination method is to correct the fastening connection part, so that it is in the correct position b the side of the roller of the dryer wears, the elimination method is according to the degree of wear, the rolling The circle is turned or replaced.
3. The moisture content of the material after drying is greater than the specified value. The elimination method is to control the production capacity of the dryer and increase or decrease the supply of heat.
4. The rolling ring has a swing on the running of the cylinder. The reason is that the side of the concave joint of the rolling ring is not clamped. The elimination method is to use the pad to keep the rolling ring and the concave joint evenly and properly clamped to prevent overtightening. It is prone to accidents.
Amino Acid,Amino Acid Powder ,Amino Acid Potassium
Vitajoy Biotech Co., Ltd. , http://www.suaminoacids.com