Store clean before storage
Most pesticides have a corrosive effect on the sprayer and should be cleaned after use. After the sprayer is deactivated, first scrub the liquid barrel, hose, spray bar, air pump and other components. Second, wash again with alkaline water (spray Bordeaux sprayer is best soaked in alkaline water for 1 to 2 hours). Finally rinse with water and dry with a cotton cloth. Avoid exposure.
Apply high-quality grease, paint rust
The detachable parts should be removed and cleaned, and the inner wall of the boom and nozzle should be washed with oil to avoid rust. Always apply high quality grease (butter) to any area where the screw is fixed or where it is frequently subjected to wear. The thin-walled iron parts can evenly paint the adjusted paint on the surface or paint off part to ensure that it will not rust for a long time.
Prevent rubber parts from sticking with oil
When applying oil rust prevention to the sprayer metal parts, care should be taken to avoid sticking oil on the rubber parts. Because rubber parts are oily, they are prone to ageing, cracking, and shortening their service life.
Store in a ventilated, dry, out of direct sunlight
Do not place the sprayer in a dark, damp corner. Do not store it in the open air. It should be placed in a ventilated, dry place and away from direct sunlight. Because many parts of the sprayer are made of rubber and plastic, these products are affected by the oxygen in the air and the ultraviolet rays in the sunlight, and are susceptible to aging and deterioration, so that the elasticity of the rubber parts is deteriorated or broken.
The spray bar breaks or sprayer cracks outside the tank to repair
Found that the spray boom breaks or cracks in the sprayer's bucket, PSI quick plastic sticks or other plastic patch repairs can be purchased. First clean up the repair site, eliminate the oil traces, and roughen the surface. Remove the colloidal quick plastic colloid from the tube and cut off the required amount. The two-color materials of the quick-speed plastic colloid and the outer skin are fully kneaded by hand and are used in one color (about 1 to 2 minutes). If it is difficult to knead under low temperature conditions, the colloid can be heated to room temperature or slightly higher than room temperature.
Anti-small animal bites
Many farmer's sprayers are damaged by rats and other small animals during storage. Therefore, the sprayer should be stored in a pest-free, rodent-damaged place, and it is best to hang it on the wall in the warehouse.
Germany imported beads
Imported French lens
mould Die-casting Eight edge type Revolving arm
Optional emergency power supply≥3 hours
Product features:
1.Ideal cold light effects.
Using the new LED cold light source, energy saving and environmental protection and long service life up to 80,000hours or more. Temperature increase over surgeon`s head < 1℃.
LED do not engender infrared ray and ultraviolet radiation, it doesn`t have the temperature rise and tissue damage caused by halogen shadowless light, can accelerate the wound healing after surgery, and has no Radiation pollution.
LED color temperature constant, soft, very close to the natural sun light.
2.Excellent shadowless effect
Lamp with the most scientific radian,Multi point light source design, so that more fullness of the light spot,When the lamps are partially occluded, also can achieve perfect shadowless effect.
Lamp panel radius of gyration: ≥182cm, the lamp can be pulled to vertical floor, convenient to any angle illumination.
3.Excellent deep lighting
4.Advanced control system
The use of liquid crystal display button control, to meet the needs of the medical staff of different patients with the brightness of the operation.
It offers illuminance memory function.
5.Universal suspension system
Rotating arm, a new type of alloy material is made of eight edge type.
Balanced system using imported arm module, more than 5 group universal joints, every cantilever must has more than 3 joints which can be rotated in 360°, The structure is light, easy to manipulate, accurate positioning, can provide the maximum range of regulation.
The equipped with fatigue correcting unit and fix position hand handle device, easy to fix position after long time use.
6.Modern laminar lamp
The thickest part of lamp-chimney is not more than 10cm.
The lamp-chimney is made of ABS, The handle on the central of lamp can be detachable, can take high temperature (≤ 134°C) sterilization treatment, easily adjust, flexible fixed.
Mobile Type LED Operating Light
Mobile Type LED Operating Light,Mobile Operating Light,Mobile LED Surgical Light,Movable LED Operating Lamp
Shandong qufu healthyou Medical Technology co.,Ltd , https://www.kangerjian-medical.com