(1) Add clean tap water to the tank. The water level should be on the specified water mark line. (2) In order to ensure the safety of operators, it is necessary to check whether the bean sprouts machine has reliable grounding measures and devices. (3) Plug in the power supply and adjust each action knob on the instrument panel to require the corresponding indicator to be sensitive. (4) Check whether the manual water spray system can spray water normally. (5) Use a thermometer to verify whether the technical performance of the heating and thermostatic device of the automatic temperature control system is normal and reliable, and whether the temperature indication value is accurate. (6) Check whether the technical performance of each part is good, whether the connection is firm everywhere, and whether there is any leakage in each part.
Second, start the production of bean sprouts should do a good job of daily management
(1) Close the door. During the production of bean sprouts, try not to open the door as much as possible to reduce the contact between bean sprouts and air. (2) Adjust each knob. According to the technical requirements of the bean sprouts machine manual, the temperature control knob, the water spray interval time control knob and the spray water duration control knob are adjusted within the specified range. (3) Observe each indicator on the instrument panel to see if it is working properly in the specified operation. (4) Observe the status of water supply and drainage. Every time water is supplied, observe whether there is any abnormality in the outlet of the drainage pipe. If any abnormality is found, open the tank door and check it in time. During troubleshooting, pay attention to the artificial watering of the growing bean sprouts on time.
Third, bean sprouts should be done after the completion of the rehabilitation
(1) Cut off the power switch first, then open the box door, take out the bean sprouts in the box, and clean the germination box. At the same time, dredge the small hole at the bottom of the box. (2) Wash the inner wall of the machine and clean the filter. (3) Check the technical condition of each part. If there is any leakage, it can be sealed with epoxy resin; if it is found that the connection is loose, it should be fastened in time. (4) Regular inspection and maintenance of the electrical components according to the instructions.
Electric Over Blanket is similar to Electric Under Blanket, but a bit different.
Electric over blanket is used by covering human body to keep warm.
Normally electric over blanket is not recommended to be used during sleeping, as it might cause overheating, although it has the function of overheating protection.
Normally over blanket shuts off after 2 hours, for the sake of safety.
Below image as reference:
Electric Over Blanket
Electric Over Blankets, Heating Cover Blanket, Heated Over Blanket, Electric Warming Blanket
Ningbo JustLive Electrical Appliance Co., Ltd , https://www.makeheat.net