After winter, it is necessary to perform a high standard maintenance on the tractor and thoroughly remove, clean, adjust, and lubricate the various parts of the tractor to ensure the oil passage, circuit communication, and water passage, and that no oil leakage or water leakage occurs. Leakage, no leakage, good starting engine when used, power, and good operation.
Frost protection
The volume expansion of the water in the tractor's cooling system after freezing will freeze the radiator, tank, body, and cylinder head. Therefore, when the minimum temperature in the winter is close to 0 degrees Celsius, the water in the cooling system must be released in time after each use of the vehicle, and it must be thoroughly cleaned.
With oil off
The diesel used in tractors is generally No.10, No.0, No.10, No.20 and No.30. The number is the temperature of the freezing point. Diesel oil contains wax, which is generally about 7°C higher than the freezing point, and there will be wax precipitation. At this time, the fluidity will be poor. Therefore, when choosing diesel oil, oil with a freezing point lower than the local temperature of 5°C to 10°C should be used. In addition, winter oil viscosity, will bring difficulties to lubrication and start should be replaced with No. 8 diesel engine oil. Lubricants in the gearbox and rear axle shall be replaced with No. 11 diesel engine oil or with No. 20 gear oil.
Start off
Before starting the engine, it is necessary to fully warm up the body, repeatedly adding and releasing hot water of 90°C or less, until the released water temperature reaches 30°C, and then hot water above 90°C is added before starting. For a locomotive using a battery, the specific gravity of the electrolyte should be increased to 1.3 to 1.4. After 25% discharge, the electrolyte should be charged to prevent the electrolyte from freezing or decreasing in specific gravity. At the time of electric start, the time for each start shall not exceed 5 seconds, and once it starts, it shall stop for 1 minute before starting again.
Safety clearance
Leave the engine idle for a few minutes after starting the engine and cover the radiator insulation curtain. Keep the water temperature above 40°C, and start the oil after the oil pressure is normal. Only when the water temperature is above 70°C can the load be operated. Traffic in winter should pay special attention to safety. Clutches, steering systems, brake systems, etc. must be carefully adjusted to make it flexible and reliable.
Fire Protection Equipment Power Monitoring System
Fire Protection Equipment Power Monitoring System,Fire Equipment Voltage Current Signal Sensor,Fire Equipment Power Monitoring Module,Fire Equipment Power Monitor
LIAONING YINGKOU TIANCHENG FIRE PROTECTION EQUIPMENT CO.,LTD , https://www.tcfiretech.com