Willow ash aliased wicker, cotton willow, tamarisk, willow, willow, willow, willow, deciduous perennial shrub. It has a high rate of winding, a thin, long wicker, and a good toughness. It is a good material for preparation. Once planted, multiple receipts. Low cost and high efficiency. The cultivation techniques of Tamarix are now described as follows:
First, choose to leave good species. In the fall, select a wicker that grows well, has full buds, is about 1 cm thick, and is free of pests and robustness. After the strips are harvested, they are tied into bundles and dug depths of 50 cm in width and 50 cm in width on the leeward sunny and well-drained land. The length can be determined according to the length of the strips. The strips are placed in the trenches and the upper cover is 20 cm thick. The fine sand is tightly covered. During storage, appropriate measures should be taken to prevent the strips from being rotted or dehydrated.
Second, plough the land and apply sufficient fertilizer. After the land is thawed in the spring, it will be determined that the cuttings will be planted 20-30 cm deep, 3,000-4,000 kg of superfine fertilizer, 50 kg of superphosphate, 75 kg of ammonium bicarbonate, 20 kg of potassium sulfate or compound fertilizer with corresponding nutrient content. After ploughing, flattening, squeezing, and then trimming, generally 185 centimeters wide, planting 5 rows of tamarix, width 45 centimeters wide, 35 centimeters within the raft, the length of the raft will depend on the length of the plot and the amount of species, generally 30 cm is appropriate.
Third, planting time and methods. Populus euphratica cuts are preferred in early spring (usually from late March to early April), and fall cuttings are usually carried out 15 days before freezing. Dig out the cuttings before the cuttings and cut them to a length of 13-15 cm. The cuts should be smooth and smooth without breaking the skin. According to the spacing of 10 cm X 35 cm, the cuttings can be inserted in a straight line and obliquely inserted. However, it is best to insert them straight and avoid direct insertion. The cuttings should be exposed to the ground about 3 cm to reveal 1-2 buds. The cutting density is between 18,000 and 220,000 per 667 square meters. Water immediately after cutting. After that, field management must be strengthened. Special attention should be given to timely snoring. Tamarix has a habit of giving birth. When the wicker is more than 1 meter tall, it begins to grow. The snoring is usually followed by a fight. When snoring, it must be taken out horizontally. Do not leave the country with the leaves. If you do so, it will injure the cortex and cause scars and affect the quality of the wicker. In addition, we must pay attention to the prevention and control of rust, aphids, leaf roller insects, larvae and other insect pests.
Fourth, timely harvest. Wicker color bar time is directly related to the quality of the wicker, taro will be harvested in the volt and autumn twice. Harvesting has affected wicker's toughness as early as possible. If harvesting is too late, peeling will not affect the preparation process quality.
Rotary Cultivator For Medium Sized Gearbox
Farm Cultivator,Rotary Cultivator for Tractor,Rotary Cultivator Machine,Rotary Tiller Farm Equipment
Shandong Dahua Machinery Co.,Ltd , https://www.agrodahua.com